Classes - Beard

You are here: start » ee674ardupilot


|

Meta

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
ee674ardupilot [2012/10/25 12:36]
robbchays
ee674ardupilot [2012/10/25 12:40]
robbchays
Line 21: Line 21:
 3. When setting up APM Mission Planner, you should load the parameter file for the plane that APM will be flying on. The parameter file for the Bixler can be found here: 3. When setting up APM Mission Planner, you should load the parameter file for the plane that APM will be flying on. The parameter file for the Bixler can be found here:
 http://​code.google.com/​p/​ardupilot-mega/​downloads/​detail?​name=bixler.param&​can=2&​q= http://​code.google.com/​p/​ardupilot-mega/​downloads/​detail?​name=bixler.param&​can=2&​q=
- 
-=== Hardware === 
-Hardware that is need to run HIL 
-  * Ardupilot Mega (APM) 
-  * Remote Control 
  
 === Software Downloads === === Software Downloads ===
Line 34: Line 29:
 X-Plane Airplane Simulator – available Windows, Linux, Mac: http://​www.x-plane.com/​downloads/​x-plane_10_demo/​\\ X-Plane Airplane Simulator – available Windows, Linux, Mac: http://​www.x-plane.com/​downloads/​x-plane_10_demo/​\\
 X-plane Bixler model (HiLStar17):​ http://​diydrones.com/​profiles/​blogs/​hilstar17-public-release\\ X-plane Bixler model (HiLStar17):​ http://​diydrones.com/​profiles/​blogs/​hilstar17-public-release\\
 +APM Bixler param file: http://​code.google.com/​p/​ardupilot-mega/​downloads/​detail?​name=bixler.param&​can=2&​q=
  
 === Notes for Software === === Notes for Software ===
Line 43: Line 39:
   * Change Weather – environment/​weather   * Change Weather – environment/​weather
   * Change Day/Time – environment/​day_time   * Change Day/Time – environment/​day_time
-  * Change Net Address - IP Address - 127.0.0.1 
-  * Change Net Address - Data ports – 49.005;​49.000;​49.105 
-  * (These numbers can be found in Mission Planner, except 49.105) 
-  * Change Aircraft 
  
 **Mission Planner notes:**\\ **Mission Planner notes:**\\
 Upon start up, command prompt screen should appear. ​ If there is a lot of writing on the command prompt and the program never loads, make sure you have DirectX downloaded (see manual/​QuickStart)!!! \\ Upon start up, command prompt screen should appear. ​ If there is a lot of writing on the command prompt and the program never loads, make sure you have DirectX downloaded (see manual/​QuickStart)!!! \\
- 
-To set home: 
-  * Flight Planner 
-  * Click home numbers(bottom right corner) 
-  * For KSEA airport 
-  * Lat - 47.431629 
-  * Lon - -122.307701 
- 
-**Hardware Setup:**\\ 
-  * Turn on remote control 
-  * Plug in battery 
-  * Plug in USB cable 
-  * Connect in Mission Planner(button in top right corner)